MOONRISE: Bringing 3D printing to the moon – Moondust melted under lunar conditions
"With these spheres, we have come a big step closer to 3D-printing on the moon", explains Niklas Gerdes, a scientific employee of the LZH. A laser system developed by the LZH was used to melt synthetically produced lunar dust, the so-called regolith, under both lunar and microgravity.
Material samples adapted to possible landing site
IRAS scientists have compiled the material samples for the experiments. "Depending on the landing site of a possible lunar mission, the composition of the lunar dust varies," explains Prof. Dr.-Ing. Enrico Stoll from IRAS. "With our mixtures, we simulate the lunar conditions as accurately as possible. We then evaluate the quality of the melted samples so that the LZH can further improve the process".
First scientific experiment in the Einstein-Elevator
The melting of the regolith was the first scientific experiment in the new Einstein-Elevator at the LUH. To be used in the elevator, the laser system and a vacuum chamber in the gondola of the elevator have been attached to an experiment carrier. The experiment carrier supplies the laser system with power and enables the controls over the system. The regolith samples are in vacuum during the experiments – just as they would be on the moon. During the flight, the laser melts a small amount of regolith, forming a sphere that cools down before landing in the experiment chamber.
Prof. Dr.-Ing. Ludger Overmeyer, LUH, describes the unique features of the large research device from Hannover as follows: "The Einstein-Elevator is equipped with long-stator linear motors. This enables us to accelerate very precisely, precisely set a vertical trajectory, but also to brake safely. In this way, we can achieve up to 300 flight attempts per day and also varying degrees of gravity." Microgravity, i.e. weightlessness, is achieved in free fall, while lunar gravity is generated when the elevator is slowed down. "This is unique to date and makes it possible to carry out statistical tests in different gravitational environments," explains Prof. Dr.-Ing. Overmeyer.
Vision: Printing building materials on the moon
"The next goal is now to test the laser system on a lunar mission," says Stefan Linke, IRAS. "If the laser system can be used to melt regolith on the moon, 3D-printed construction material on the moon will come closer and with it the realization of the vision of a lunar colony".back to overview